LT-1 engine towers, what to use???
 

Ok I just got my LT-1 in and I have a cople questions. I am a bit confused, I want to use the further back position to mount the motor so I have more clearance for the radiator fans and what not.

So what do I use the V-8 towers in the rear location?
Or do I use the I-6 towers in the rear location?
Then what motor mounts do I use?

Re: LT-1 engine towers, what to use???
 

V8 mounts in the rear holes and I think I used the caged style older chevy camero mounts:confused:

Kevin
LFD Inc.

Re: LT-1 engine towers, what to use???
 

http://www.classicperform.com/tech_a...ngine-Swap.htm

This may help

Re: LT-1 engine towers, what to use???
 

Yeah I have seen that, but thats for gen III LS motors, I have a gen II LT-1.
Thanks though.

Re: LT-1 engine towers, what to use???
 

ttt

Re: LT-1 engine towers, what to use???
 

You can use the 6 cylinder mounts in the 6 cyl position

Re: LT-1 engine towers, what to use???
 

Go to hotrodlane.com. IT is Street and Performance. They can answer your question. That is who I used. I don't remember exactly what I did. Lambert there should have your answer. Kerry

Re: LT-1 engine towers, what to use???
 

just pick up some I6 towers which mount in the rear position.

if you can wait a couple weeks, i have a pair you can have, otherwise check the classified section, they're always popping up pretty cheap. :)

Re: LT-1 engine towers, what to use???
 

Thanks I have some one who has a set for me locally I just wanted to make sure I needed the I-6 towers.

Now what do I use for the motor mounts on those towers?