argh!!
 

I have hit a little bit of a wall while trying to put the windwing back in my truck. I took it apart, replaced the seal, and now it seems physically impossible to re-install. Do I need to take the windwing out of the window channel and then pop it back in after it's most of the way in? Any suggestions will be appreciated at this point. Hard to drive around like it is now.:(

Re: argh!!
 

Here's a couple of pictures -

Re: argh!!
 

Here's another -

Re: argh!!
 

Take you big window off the rear track and slide it back. Install wing and then big window.

Re: argh!!
 

I would remove the rear track that the long felt fits in and just slide the window back without removing it from the track, thats how we've done it before, easier I think.

Re: argh!!
 

Loosen/remove the 3 bolts? I'm having a hard time convincing the screw in the back of the door to come loose. It is fro-zun. I'll let it soak with a litttle WD40 overnight, I guess. But it's those three screws, right? The two just under the panel on the inside of the door, and the one above the latch screws on the back of the door?

Re: argh!!
 

Yes that is the track I am talking about.