The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   The 1967-1972 Chevrolet & GMC Pickups Parts Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=8)
-   -   Looking for frame parts (https://67-72chevytrucks.com/vboard/showthread.php?t=261594)

too much stuff 10-07-2007 11:32 PM
Looking for frame parts
 
Looking for the rear frame rails (both sides) for a 69 short 4x4. About the last 12" or so. I am not sure if the 2wd coil spring trucks share the same rails or not. Shipping would be to 55744. Thanks

1969k10stepside 10-07-2007 11:35 PM
Re: Looking for frame parts
 
I think the 2wd rear frame parts should work.Are you needing past the rear crossmember? It's been a few years since I've had a 2wd 67-72 but I think the frame is the same past the last crossmember up a few feet till you get near the axle.The holes for the spring hangers will have to be drilled though.

4bynut 10-08-2007 12:14 PM
Re: Looking for frame parts
 
They are the same. I'm using the back section of frame on my 67 SWB 4x4. The PO had a flat bed on it and welded some other stuff to it. What a mess. I'm replacing a little in front of the last crossmember so i get it also. I don't want to bolt a new one in. Jason

too much stuff 10-08-2007 03:18 PM
Re: Looking for frame parts
 
Thanks for the info. Anyone cutting up a frame that is fairly clean towards the back?
4bynut, i have a similar situation, but with some rust thrown in for good measure!! You should have seen the channel iron bumper that was on this thing. Eric

duallyjams 10-08-2007 06:24 PM
Re: Looking for frame parts
 
I have a 72 4x4 blazer frame for sale but i don't if its the same or not, maybe some one chime in with the answer.

too much stuff 10-09-2007 09:22 PM
Re: Looking for frame parts
 
Still looking...

71big block 10-09-2007 09:30 PM
Re: Looking for frame parts
 
I have a 72 C20 I'm going be cutting up the weekend of the 20th, send me a pic of what you need, you can have it if you pay the shipping

too much stuff 10-09-2007 09:46 PM
Re: Looking for frame parts
 
Cool, thanks for the offer. I am looking for where the rear bumper would bolt on. About up to the rear cross member. The frame is not here at the moment, so it is tough to get a pic for you. Can you check the condition of the last 12-16 inches of the frame and let me know? Thanks, Eric

vintagechevy76 10-20-2007 02:10 AM
Re: Looking for frame parts
 
I have a 72 c20 2 wheel drive frame im cutting up too and the frame is perfect. Let me know if you still need the rails.

too much stuff 10-20-2007 07:46 PM
Re: Looking for frame parts
 
It looks like i found some close to home from another board member. Thanks for the responses, Eric


All times are GMT -4. The time now is 03:42 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com