The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   The 1960 - 1966 Chevrolet & GMC Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=6)
-   -   65 gmc stepside questions (https://67-72chevytrucks.com/vboard/showthread.php?t=31739)

abwdvm 11-30-2002 12:09 AM

65 gmc stepside questions
 
I have a 65 gmc step side. Few questions.

1. It has rear leaf springs, I thought it should have rear coils.

2. Planning on swapping a 73 chevy front cradle in for disk brakes and 5 bolt rims. Any advice on this?

3. Any way to docode the number on the little silver plate above the door post?


ABW

Demmit_Hemmit's 65 11-30-2002 05:58 AM

abwdvm.................your right it should have coil springs........Yes you can decode the plate above the door pillar.........Give some numbers and I'll see what I can do for you.................HEMMIT

abwdvm 11-30-2002 11:39 AM

OK, titled 65 gmc, step side, 230, 3 speed. This truck has a 250 engine, was told the 230 went bad and was dealer replaced. I am the second owner, and I dont think the 1st owner would have modified the rear suspension.

Silver Tag

GMC TRUCK DD

l 1001 P F36106A


Donor Cab (351E engine)

GMC TRUCK DD

1002 p F45286A

C10 - C90 Bill 12-08-2002 10:03 PM

Hey abwdvm, 1. In those years GMC trucks, leaf springs were standard, where in Chevrolet, coils were standard. 2. Not familiar with that swap, but it sounds like a lot of work. If it were my truck, I would be leaving it original, but that's just my opinion.

abwdvm 12-09-2002 04:27 PM

65 gmc
 
Thanks! I thought it looked stock. I am pleased with the 3.54 ratio back there. Only thing I dont like is the 6 bolt axels. Wonder if I can use my 5 bolt axels and drum from the 73?

ABW


All times are GMT -4. The time now is 07:25 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com