Power Steering bracket hardware
 

Hey gang, does anyone have their power steering pump off at the moment that could give me the appropriate bolt measurements (thread-pitch x length) for the two that go into the block, next to the crank? I've got all the others, but I don't have a fist full of misc hardware to try in there at present.

Thanks
~Dan

EDIT: Its the style with those two bolts and an arm that attaches to the motor mount. (307, original motor)

Re: Power Steering bracket hardware
 

I can take some pics of mine tomorow, Im not good at figuring out the size lol...dad can though.

(your talking about the bolts the hold the bracket to the block) ?

Re: Power Steering bracket hardware
 

Aye, those ones. Thanks!

Re: Power Steering bracket hardware
 

Ok, I just got home i'll go take one out and take a pic with the good camera...dads not home though...

Ps, its the same size bolt that goes in your intake manifold (non vortec)

Re: Power Steering bracket hardware
 

The bolt threads are 3/8-16. I use bolts that are 2" long but the holes need to have the threads cleaned up as they will bottom out slightly. I believe that the factory bolts were 1 3/4" long but most bolts come in 1/2" increments so 2" is the closest that I could come up with.

Jim

Re: Power Steering bracket hardware
 

Rockin', thank you.