DIY fuse panel/relay for LS motor
 

Guys,

If I plan on running the factory 5.3 motor in my truck, is there any reason to get a stand alone fuse/relay panel to control my fuel pump?

Has anyone used the factory junction box in their project?

David
________

Re: DIY fuse panel/relay for LS motor
 

Second thought,

Nevermind.

Re: DIY fuse panel/relay for LS motor
 

Not sure if this is what you are asking but I hope it helps. It is located in the
"Ls engine swap info" stickyThread ... the link inside that thread says "LT1swap" Lots of wiring info.

http://lt1swap.com/underhoodfuseblock.htm

Re: DIY fuse panel/relay for LS motor
 

Harrol,
Good call on that link.

I forgot to grab the junction block when I picked up the motor...I wasn't thinking.

Re: DIY fuse panel/relay for LS motor
 

I posted this in my build thread that you asked about, but here it is again...first item on this page is what I used:


http://www.currentperformance.com/Ac...iring_acc.html

Also, I have a factory fuse block that I didn't use.

Re: DIY fuse panel/relay for LS motor
 

You used this with the factory ecu, right?