Brake rod pictures for WEBBES
 

Here is a picture of the part that connects the brake master cylinder rod to the brake pedal arm.

Re: Brake rod pictures for WEBBES
 

and if you're looking to fab a rod, you need about a 1 ft long piece of 7/16-20 (if memory serves correct) threaded rod to screw into the long piece.

Re: Brake rod pictures for WEBBES
 

I think mine ended up about 11 inches total length, and I used a grinder to taper the end that went into the master cylinder. Just make sure you get it centered in the bore so it doesn't bind. Once you get it adjusted, tighten down the jamb nut and drive.

Re: Brake rod pictures for WEBBES
 

Sorry I did not explain better but WEBBES has a rod that came with a brake kit but it did not come with the pedal end so I was showing him the pedal end of the rod. Thanks for the information. Todd

Re: Brake rod pictures for WEBBES
 

I had the exact opposite happen. My trucks PO had butchered the part that passes into the firewall, and had a 2 year old weld it back together crooked about an inch from where it passed through.