The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   The 1967 - 1972 Chevrolet & GMC Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=3)
-   -   Key cylinder on drivers side door (https://67-72chevytrucks.com/vboard/showthread.php?t=446723)

Btc10 02-14-2011 02:33 AM

Key cylinder on drivers side door
 
My key cylinder was working just fine until I put my new weatherstripping in and it won't lock when I shut the door all the way but, when the door is shut half the way it will lock. Can somebody help me find a way to get the door to lock all the way?:chevy:

JimKshortstep4x4 02-14-2011 06:33 AM

Re: Key cylinder on drivers side door
 
Try pushing in on the door when you are trying to turn the key.

Jim

LockDoc 02-14-2011 10:28 AM

Re: Key cylinder on drivers side door
 
-
I think Jim has the answer. It is because there is too much pressure on the door latch. If it is hard to lock you can move the striker plate on the door jamb out a little. Just be sure to mark around it with a fine felt tip marker before you loosen the bolts so you know where it was originally. I would only move it out about 1/16th of an inch to start with. Make sure it doesn't drop down any....

LockDoc

steelscout 02-14-2011 10:34 AM

Re: Key cylinder on drivers side door
 
Have you tried poking a few needle sized holes into it? might release some of the air caught up in it.

Btc10 02-14-2011 03:25 PM

Re: Key cylinder on drivers side door
 
Okay I will try that and I will let you know if it works. No I haven't tried the needles.

Btc10 02-15-2011 05:12 PM

Re: Key cylinder on drivers side door
 
I put a shim in the striker like yall told me and moved the striker forward a little bit and I put some pressure on the door and the door locked. Thank yall for the info.

LockDoc 02-15-2011 05:53 PM

Re: Key cylinder on drivers side door
 
Quote:

Originally Posted by Btc10 (Post 4488613)
I put a shim in the striker like yall told me and moved the striker forward a little bit and I put some pressure on the door and the door locked. Thank yall for the info.

Actually, by move it out I meant to slide it towards the outside of the truck so the door doesn't close so tight but if that worked all is well...:)

LockDoc


All times are GMT -4. The time now is 12:29 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com