help motor mount
 

i took pictures but doing this thread on my break at work.i have a motor mounts that were bolted to engine i bought privatley.they are u shaped with a hole on either side that the bolt goes through.the truck i bought had a 350 in it a one time.there is a lower bracket bolted to the frame there is a hole on the top.would there be a lower mount with rubber mount to this.is there something missing here i will upload pictures later.trying to describe the best i can.thanks

Re: help motor mount
 

Whats your question?

Re: help motor mount
 

You might want to take a look at this thread and see if it answers your question:

http://67-72chevytrucks.com/vboard/s...ht=motor+mount

The O'Reilly link isn't working correctly, so when you get there just type in 2282 and on the next page the item in the middle will be the motor mount that bolts to the engine.

Re: help motor mount
 

wrong mounts

Re: help motor mount
 

yes that doesn't look right.i will post the pictures later.

Re: help motor mount
 

here is a picture of the mount attached to the block picture 1 .the second picture is close what i have in the truck.there is one hole on the top of the mount.not the two holes as seen here.whats missing ?Attachment 761795

Attachment 761796

Re: help motor mount
 

you can change to the earlier mount on the eng and it will bolt to the existing perch or get a later perch and install that and it will bolt up to that mount on the eng. there may be a difference in height though
ron

Re: help motor mount
 

You need the mounts for the original small block perches 7-509BL $90 bucks for a good set from CPP, or for bout $40 bucks more you could switch to the CPP perches, here is a pic, excellent quality and use the mounts you have.

Re: help motor mount
 

The motor mount bracket on your engine is for the '73 and up motor mounts. Just remove that from your engine, and bolt on a set of motor mounts for a '63-'66 truck with a V8. They should be the number 2282 that Mark posted. You will also need a couple 7/16"-14 bolts about 1-1/4" long as well as a couple 7/16" flat washers. I'm not sure how easy those bolts and washers will be to find up in BC though

Re: help motor mount
 

there is more sae thread avail for sale than metric here; no problem
ron