6.0 LQ4 Drive by cable
 

Im getting ready to install the 6.0 engine into the 71 and just realized its a drive by cable. To be honest, I never payed much attention as I was planning to do a carbed set-up at the time. But after month's of reading, I realized I'd be a fool to not run the fuel injection. Unfortuanetly I wasn't aware that I needed the gas pedal and tac module when I got the engine.

Has anyone just used the stock pedal assembly? I realize the drive by wire is an easier set-up for cruise control, but cruise is not that important at this time, and I dont want to change intakes.

Any help appreciated

Re: 6.0 LQ4 Drive by cable
 

You can use a cable actuated throttle but you have to change the t-body. If you keep the drive by wire you have to get the electronic pedal. There is also a short dedicated wire harness that goes from the pedal to the electronic t-body.

Re: 6.0 LQ4 Drive by cable
 

If you keep the drive by wire, you have cruise control built into the tac module and all that would be missing is the cruise wiring. That would be a plus