Grill swap question
 

Hi guys,
I own a 62' c10 with the original grill & am contemplating putting a 63' c10 grill on my truck.Besides the grill itself, what if any other parts will I need to do this ? Any fab/custom work,necessary ? Thanks as always !
Posted via Mobile Device

Re: Grill swap question
 

62 to 63 should be a straight bolt in , no problems

Re: Grill swap question
 

Great ! So do I need any other 63' parts to hang this grill on my 62' I've no experience with sheetmetal stuff...thanks again.
Posted via Mobile Device

Re: Grill swap question
 

nope as long as the 63 grille is complete , just unbolt it from a 63, and bolt it onto your 62

Re: Grill swap question
 

What a country ! Lol thanks
Posted via Mobile Device

Re: Grill swap question
 

I thought the grill mounting locations were different for 62-63? 63 Has 4 bolts that hold it on. The grill support is the same, but I believe the mounting points are going to have to be drilled.

Re: Grill swap question
 

As far as I know 60-63 and gmc use the same mount points.

Re: Grill swap question
 

Ha! I was wrong...just went in the shop, looks like they use the same top 2 mounts, but the lower were different on gmc, chev 60-61, and 63.
I will put my 62 and 63 grilles next to each other when I go out to the yard later today, and get you some exact measurements, you might have to drill a couple holes for the bottom.

luckily the top outer corner mounts are in the same spot on all 60-66, so if needed you can hold any grille in that way, I did that when I ran a 62 grille in my 65 for a few weeks.

Re: Grill swap question
 

That's great, at least I have 2 factory holes (no laughing !)to use foe alignment.I should have the grill this weekend.
Posted via Mobile Device

Re: Grill swap question
 

I got the grill today, decent shape & surface rust only, one small dent near the pass. Side headlight. I'm gonna clean it up a bit then hang/mock it up before the truck goes into the body shop (yes !) I am missing the bezels....hint,hint.
Posted via Mobile Device