The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   The 1967-1972 Chevrolet & GMC Pickups Parts Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=8)
-   -   CA WTB 5 lug axles (https://67-72chevytrucks.com/vboard/showthread.php?t=550993)

shawno72 11-08-2012 01:18 AM

WTB 5 lug axles
 
I know this is probably a long shot but I'll give it a try. I am looking for a set of 5 lug axles or conversion axles for my 68 rear end. They obviously need to be for the narrow rear end. Let me know what you have and how much shipping would be to a 95240 business address. Please respond in thread.
Posted via Mobile Device

ortegamotor 11-08-2012 09:52 AM

Re: WTB 5 lug axles
 
I have a set..... I'll just need to make sure they're the right size. I actually have two sets. do you know how long they need to be?

shawno72 11-08-2012 10:06 AM

Re: WTB 5 lug axles
 
Actually I don't but I know they are shorter than the later 70-72 axles and I have a set of those so let me measure them and we will go from there. I'm guessing since the early axle housing is 1 1/2" short then the axle should be 3/4" shorter?
Posted via Mobile Device

CC69Rat 11-08-2012 10:55 AM

Re: WTB 5 lug axles
 
I looked at mine (Moser, for the late rear end) and they are 31 5/16 "

.. but the Moser for the early rear end shows 30 1/2 "


Adding 3/4 per side that's within 1/16". 30.5 + .75 = 31.25 (31 1/4") I will tell ya, when I put the pin back in mine , the tolerances were spot on. You couldn't get it any closer. Just a light bump to get the pin to go back between the axle ends, but you could push it back out with your finger. It was definitely not as loose as with the original 6 luggers.

So, I'm thinking the shorties are 30.5" long per side. That help? Running stock 5 lug axles, you should be really close with 30.5"

Mosers are $260 + bearings and seals. Just FYI.

shawno72 11-08-2012 11:02 AM

Re: WTB 5 lug axles
 
Thanks Chad that helps a bunch. Where did you buy your Mosers from? Tony what do your axles measure?
Posted via Mobile Device

CC69Rat 11-08-2012 11:39 AM

Re: WTB 5 lug axles
 
Ordered mine straight from MEng. Super happy with them. 1/2 in studs, just FYI.
Posted via Mobile Device

shawno72 11-08-2012 12:17 PM

Re: WTB 5 lug axles
 
Quote:

Originally Posted by CC69Rat (Post 5691831)
Ordered mine straight from MEng. Super happy with them. 1/2 in studs, just FYI.
Posted via Mobile Device

Is 1/2 studs the stock size and do they come with lug nuts?

cericd 11-08-2012 12:27 PM

Re: WTB 5 lug axles
 
Hey Shawn and Chad. Got a question for y'all. I recently measured the rear end on my '70 C10. Turns out, it's the wider one. I plan to do the five lug swap too so would Shawn's longer set work for me (assuming you're looking for the shorter set as a replacement)?

shawno72 11-08-2012 12:38 PM

Re: WTB 5 lug axles
 
Quote:

Originally Posted by cericd (Post 5691899)
Hey Shawn and Chad. Got a question for y'all. I recently measured the rear end on my '70 C10. Turns out, it's the wider one. I plan to do the five lug swap too so would Shawn's longer set work for me (assuming you're looking for the shorter set as a replacement)?

Yes and no. :lol: For you the swap will be easy, just find a 71-72 5 lug rear end and steal the axles. I have the early 6 lug rear end which is narrower to start so I need a set of aftermarket conversion axles. Sorry I can't help you there.

CC69Rat 11-08-2012 01:56 PM

Re: WTB 5 lug axles
 
You'd need the longer version axles. (same as mine Chris) Stock / Aftermarket .. either way. Same legth.

7/16 is stock Shawn. 1/2 is usually Ford. My truck is all 1/2 now. So, saying if you do Mosers you will likely need new lugs too.

CC69Rat 11-08-2012 01:57 PM

Re: WTB 5 lug axles
 
Lug nuts sold seperately.. Some assembly required. :D

(studs are pressed in when you get them too)

lolife99 11-08-2012 02:21 PM

Re: WTB 5 lug axles
 
Quote:

Originally Posted by CC69Rat (Post 5691995)
You'd need the longer version axles. (same as mine Chris) Stock / Aftermarket .. either way. Same legth.

7/16 is stock Shawn. 1/2 is usually Ford. My truck is all 1/2 now. So, saying if you do Mosers you will likely need new lugs too.

7/16" is stock for pre-'71 6-lug trucks.
1/2" is stock for 71-87 5-lug trucks.

shawno72 11-08-2012 02:29 PM

Re: WTB 5 lug axles
 
Quote:

Originally Posted by CC69Rat (Post 5691995)
You'd need the longer version axles. (same as mine Chris) Stock / Aftermarket .. either way. Same legth.

7/16 is stock Shawn. 1/2 is usually Ford. My truck is all 1/2 now. So, saying if you do Mosers you will likely need new lugs too.

Quote:

Originally Posted by lolife99 (Post 5692031)
7/16" is stock for pre-'71 6-lug trucks.
1/2" is stock for 71-87 5-lug trucks.

Thanks guys, I knew there was a differance between the 5 and the 6 lug, I just couldn't remember which way it was ;)

shawno72 11-08-2012 04:47 PM

Re: WTB 5 lug axles
 
I found this on the Summit website, looks like I need the 30 1/2" axles.
http://www.summitracing.com/parts/ms...del/c10-pickup

CC69Rat 11-08-2012 04:55 PM

Re: WTB 5 lug axles
 
1 Attachment(s)
Yep.. they're sweet man.

shawno72 11-08-2012 05:49 PM

Re: WTB 5 lug axles
 
Will the stock bearing work? I just put in new seals and bearings and would hate to buy new ones if I didn't have to.

CC69Rat 11-08-2012 06:02 PM

Re: WTB 5 lug axles
 
Yeah.. if theyre new, Id think youre good. The ones I got from Moser were just Napa bearings. Id say theyre just stock spec but maybe call and ask to be sure?
Posted via Mobile Device

shawno72 11-08-2012 06:15 PM

Re: WTB 5 lug axles
 
I will, thanks Chad. Tony put down the wrenches for a moment and take a measurement :lol:

shawno72 11-09-2012 02:24 PM

Re: WTB 5 lug axles
 
ttt looking for a pair of 30.5" 5 lug axles

CC69Rat 11-09-2012 03:05 PM

Re: WTB 5 lug axles
 
Most shorties out there will all be 6 lug. Id say if they are short 5 lug, theyre likely aftermarket.
Posted via Mobile Device

shawno72 11-09-2012 03:40 PM

Re: WTB 5 lug axles
 
Quote:

Originally Posted by CC69Rat (Post 5693810)
Most shorties out there will all be 6 lug. Id say if they are short 5 lug, theyre likely aftermarket.
Posted via Mobile Device

Yeah I'm almost positive they are gonna be aftermarket, I was just hoping to catch someone maybe going a different direction with their build or ordered the wrong set or just wanting to help a brother out.....:lol::lol:

CC69Rat 11-09-2012 03:42 PM

Re: WTB 5 lug axles
 
Buy my 68 step. It has some in it. :D. 3:73 too...
Posted via Mobile Device

HotRod C/10 11-09-2012 03:47 PM

Re: WTB 5 lug axles
 
I got my mosers for short diff at Summit Racing.
Posted via Mobile Device

shawno72 11-09-2012 03:47 PM

Re: WTB 5 lug axles
 
I just sold my 3.73 gear set ;) No chance of parting that thing out, huh?? :)

ortegamotor 11-09-2012 03:58 PM

Re: WTB 5 lug axles
 
2 Attachment(s)
Dude I totally dropped the ball. I just ran out to the shop to measure those axls they look to be 30.5 I think thats what you're looking for . PM me for info and my #



Tony


All times are GMT -4. The time now is 11:27 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com