Help! k20 rotor removal with sears/selectro hubs
 

Hey guys,

I'm trying to take the rotors off my Blazer but am having a hard time.
Truck is a 70 Blazer with 3/4 axles. 10 bolt up front.

I've removed the locking hubs but cannot seem to get to (or even see) the nut to take off the rotor. It has sears/selectro hubs on it and when I look online, all the pictures I find are different.

Its a possibility that I'm half stupid though LoL

Re: Help! k20 rotor removal with sears/selectro hubs
 

Here's some pics

http://i173.photobucket.com/albums/w...23E04DBDFF.jpg

http://i173.photobucket.com/albums/w...2402F0E88E.jpg

http://i173.photobucket.com/albums/w...241FE43FF5.jpg

http://i173.photobucket.com/albums/w...2439F56F8B.jpg
Posted via Mobile Device
Posted via Mobile Device

Re: Help! k20 rotor removal with sears/selectro hubs
 

Is there a snap ring between the hub and the selector? Could be a round one.

Re: Help! k20 rotor removal with sears/selectro hubs
 

http://i173.photobucket.com/albums/w...27D16DE2DE.jpg

Not sure if this is a diagram for my axle.
Posted via Mobile Device

Re: Help! k20 rotor removal with sears/selectro hubs
 

I can't see any snap rings in there. When I go back tomorrow I'm going to clean the crap out of it with brake clean so I can see in there better.
Posted via Mobile Device

Re: Help! k20 rotor removal with sears/selectro hubs
 

I think you can push that hub in and then there's a snap ring on the shaft.

Also once you get the rotors off you pound the studs out to seperate the rotor from the hub.

Re: Help! k20 rotor removal with sears/selectro hubs
 

You should have 2 snap rings.
1. The large ring where the hub and the spine gear come togther.
2. The small ring where the axle shaft and the drive shaft gear.

see pic below

Re: Help! k20 rotor removal with sears/selectro hubs
 

I have the same setup. Do you know how to remove it????:smoke: