The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   The 1960 - 1966 Chevrolet & GMC Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=6)
-   -   Turn signal cam removal (https://67-72chevytrucks.com/vboard/showthread.php?t=564027)

Buckthetruck 02-01-2013 06:46 PM

Turn signal cam removal
 
1 Attachment(s)
I have a new turn signal cam to install, but the old one will not come out. Is there another screw holding it in that I cannot find? Looking at the new one, I expected it to just slip off and the new one go in. But it does not want to come off.
Posted via Mobile Device

Buckthetruck 02-01-2013 07:07 PM

Re: Turn signal cam removal
 
Ok, I pulled the whole assembly out and found the holding screw. Now that the new one is in, the rear signals work easily, but the dash signal and front signals don't work unless I push the lever up a little beyond the catch. Any suggestions on adjusting this so it works right? Thanks
Posted via Mobile Device

62ss409 02-01-2013 11:09 PM

Re: Turn signal cam removal
 
If I remember correctly, I had to bend the horseshow shaped spring a little bit more towards the centre. Slightly, only


All times are GMT -4. The time now is 04:19 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com