Control arm shaft centering tolerances
 

So i installed new bushings and shafts in my upper control arms and as far as the shafts being centered, one control arm was off .070" and the other was .072" off center. what i did was indicate each shaft hole and used an edge finder and bumped up to the side of the arm. Is this something to be concerned about? I really dont want to take these apart again.

Re: Control arm shaft centering tolerances
 

To make sure the measurements are correct... it is .072" as in less than 1/8" correct? Not .72" as in almost 3/4"?

If it is only .072" and .070" you should not worry about it. That's probably a tighter tolerance than 99% of them came with from the factory. :)

Nate

Re: Control arm shaft centering tolerances
 

yea that's correct .070 thousandths, thanks for answer I appreciate it.

Re: Control arm shaft centering tolerances
 

No worries... these trucks came with over a 1/2" tolerance from the factory. It will drive guys like us CRAZY!!!! :waah:

Nate