The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   The 1973 - 1987 Chevrolet & GMC Squarebody Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=4)
-   -   Which adhesive for sticking stuff to the body? (https://67-72chevytrucks.com/vboard/showthread.php?t=578800)

Skunksmash 05-04-2013 11:14 PM

Which adhesive for sticking stuff to the body?
 
I just had my truck painted, but to save a little cash I'm doing some of the things myself. It needs a new silverado badge, and I don't really want to take the fender off. I want to glue it on there. Also, I didn't buy those off-kilter looking trim pieces that that wrap around the bed under the tail lights. I just used the same trim that goes on the sides so that it would all look uniform. So of course I will need some stronger adhesive so that those don't come off.

Which adhesive should I use for permanently gluing stuff directly to the paint?

BMERDOC 05-04-2013 11:21 PM

Re: Which adhesive for sticking stuff to the body?
 
Use 3M double sided tape. You can get it in rolls so you can trim off what you need. Cleans up somewhat easily if you have to remove it.

andrewmp6 05-04-2013 11:25 PM

Re: Which adhesive for sticking stuff to the body?
 
Yeah the 3m tape is what most vent visors are held on with.

bilfman 05-04-2013 11:47 PM

Re: Which adhesive for sticking stuff to the body?
 
X3 on the 3m tape. 3m products are top shelf!
Posted via Mobile Device

Skunksmash 05-04-2013 11:50 PM

Re: Which adhesive for sticking stuff to the body?
 
Ok I will get the 3M tape. There are many 3M tapes, but I take it this would be the only one for use on the exterior? Also since it is a tape, is it going to make the fender badge look like its sticking out slightly further than the other side is?

I have to admit I'm a little leery of using a tape to make sure these things don't eventually just fall off the truck when I'm driving down the road.

bilfman 05-05-2013 12:04 AM

Re: Which adhesive for sticking stuff to the body?
 
I've heard it referred to as body molding tape. Don't worry about it sticking. If both surfaces are clean you need a pry bar to get it off.
Posted via Mobile Device

Damon23 05-05-2013 12:07 AM

Re: Which adhesive for sticking stuff to the body?
 
I bought a huge roll off eBay years ago. It is half inch wide and thin. Works great. Didn't make the emblems I was putting on my old bronco stick out too much.
Posted via Mobile Device

Skunksmash 05-05-2013 12:08 AM

Re: Which adhesive for sticking stuff to the body?
 
Here it is:


http://www.3m.com/product/informatio...ding-Tape.html

motornut 05-07-2013 06:56 AM

Re: Which adhesive for sticking stuff to the body?
 
spend a bit extra for good stuff
I found other uses too
don't make a pocket sealed by it,keeping ,moisture and dirt trapped

BONUSCAB 05-07-2013 06:46 PM

Re: Which adhesive for sticking stuff to the body?
 
Any pics?

Damon23 05-07-2013 09:12 PM

Re: Which adhesive for sticking stuff to the body?
 
If you don't need it like yesterday I'll take some off this roll I have and send it to you if you'd like to try it out. It is 3M and is about the thickness of the stuff skunksmash posted but is not as wide. Just PM me your address and I should be able to get it out in the next few days.


All times are GMT -4. The time now is 08:18 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com