WTB: Seat belt bolt
 

Hey all! Got the third row installed in the suburban but I am short 1 seat belt bolt that mounts to the seat brackets. I think all of the seat belt bolts are the same though. Price shipped to 91208 please. Thanks!!
Shawn
Posted via Mobile Device

Re: WTB: Seat belt bolt
 

I think I have an extra one I will give you. $3.00 should cover shipping from NC to CA. Could you give me a length on it to make sure I do send you the right one.

Re: WTB: Seat belt bolt
 

I could help ya...going to Brother's show?!

Re: WTB: Seat belt bolt
 

The easiest thing would be to head down to your local Ace or True Value and get a Grade 8 bolt. Shouldn't be more than a couple bucks.

When I replaced the seatbelts in my pickup I wanted to replace the bolts too, but I came up one or two bolts short. A trip to the hardware store and I was good to go.

Re: WTB: Seat belt bolt
 

Hey guys. Thanks for the replies! Sorry for the delay. I was just finishing up the fuel lines on the ls swap in the suburban. They come to tune it tomorrow evening and then to the exhaust shop to connect the old to the new. Then I'm done with the burb for the moment. I'm not sure on the length. I will check that later. When is the brothers show? I was going to get the bolts from the local hardware store, but would prefer the correct ste bolt with the collar for the seatbelt.
Posted via Mobile Device

Re: WTB: Seat belt bolt
 

Re: WTB: Seat belt bolt
 

I think I have one too that you can have if the other guys don't work out.

Re: WTB: Seat belt bolt
 

Thank you guys!! Y'all are awesome. I will get the dimensions. I want to go to the Brothers show this weekend, but I'm just not sure if I can make that happen.
Posted via Mobile Device

Re: WTB: Seat belt bolt
 

I would recommend using the correct OE seatbelt bolt as it will fit the belt end properly. Other than rust the originals should be just fine as far as integrity.