Hood/cowl hinge pads
 

Does anyone know where to get these rubber/foam pads located at the bottom of the hinges on the cowl? Also, what is the foam pad between the fender and the cowl in the second pic? Is this part available also? GM part numbers would help. It looks like the part numbers have been superceded more than once. Thanks.

Re: Hood/cowl hinge pads
 

i want to know where i can get the rubber pieces for the hinges too !


**BUMP**

Re: Hood/cowl hinge pads
 

LMC carries them ;)

Re: Hood/cowl hinge pads
 

Can you tell me the LMC part number? I don't see them in the catalog. Thanks.

Re: Hood/cowl hinge pads
 

OK. I see the parts in the online catalog now. They were not in my latest paper catalog from LMC.

Does anybody know about that foam cushion between the fender and the A pillar/cowl area? Is it an anti-squeak device or is it a water seal? This is the second pic in my original post.

Thanks.

Re: Hood/cowl hinge pads
 

part number? I dont see it.
Also there was a rubber pad about an inch thick and 3 inches long glued on the bottom of the cowl on both sides. I dont see that anywhere.

I cant wrap my brain around your picture. can you take one from farther away.

Re: Hood/cowl hinge pads
 

that foam is there to absorb water and cause a nice rust spot, most GM cars have them in and around the a pillars. I always remove those. Sure they are probably for some kind of noise or rattle issue but I'd rather have a rattle then rust

Re: Hood/cowl hinge pads
 

did anyone else have trouble putting these pack on? Seems i stripped on side on mine like the screw holes got pulled up

Re: Hood/cowl hinge pads
 

I think your looking at this...was my 87

Re: Hood/cowl hinge pads
 

Are they number 6 on 81-87 trucks?

http://www.lmctruck.com/icatalog/cc/full.aspx?Page=33

http://www.lmctruck.com/icatalog/cc/865w/0033.jpg

Re: Hood/cowl hinge pads
 

Yes, #6 in that catalog listing