Picks of stock retracting seat belt installed
 

Ran into a lil issue with the installation of a factory set of retracting lap belts, when I install them the lean into the door when it is closed, there is only 1 mounting hole in the floor to install, is the mounting hole the same as the shoulder belt mount?

Re: Picks of stock retracting seat belt installed
 

Anyone?

Re: Picks of stock retracting seat belt installed
 

Here's an old one that I have. I'll look to see if I have others. And, if you need a particular pic I can get you one tomorrow.

Re: Picks of stock retracting seat belt installed
 

Here's another one I found.

Re: Picks of stock retracting seat belt installed
 

If your truck is a 67, both the floor and shoulder mounts use a 7/16- 20 bolt (fine thread) 68-72 trucks use a 1/2- 18 bolt (course thread) for the floor mounts. All 67-72 trucks use a 7/16- 20 for the shoulder mounts.
Posted via Mobile Device

Re: Picks of stock retracting seat belt installed
 

Thanks 68gmsee, mine looks to mount the same spot but it leans on a 60-70 degree angle towards the door I will post a pick later.

Re: Picks of stock retracting seat belt installed
 

They do have a little bend to them. Maybe you have the left and right switched. My 2 cents.