My full exhaust the hard way
 

Got tired of the noise of short exhaust and finally one got torn off by a curb ,so I knew I had to do some rust repair on the floor and after digging through the rust I decided to replace the whole floor[,how hard could that be] a new floor was too much money .Got the floor torn out and decided to do the exhaust.Got some pipe bent the way I thought it should be and welded them together,just have to put on the turnouts and done.

Re: My full exhaust the hard way
 

I used .063 1 in. sq. tubing and using 14 gauge for the floor.Now I have to try and make some wheel tubs

Re: My full exhaust the hard way
 

I still have to put in a couple more cross braces

Re: My full exhaust the hard way
 

How far up did you move the floor?

Re: My full exhaust the hard way
 

This is what I plan to do when I bag my blazer. Looking good!

Re: My full exhaust the hard way
 

Also is that bench using some sort of stock mounting hardware or homemade?

Re: My full exhaust the hard way
 

It,s up 2 inchs

Re: My full exhaust the hard way
 

I,m using a bench seat,I didn,t want the rear seat but wanted room for 3 if needed.I made the brackets for it,was quite easy.I like the old look ,didn,t want any fancy buckets or bench seats

Re: My full exhaust the hard way
 

Here is a pic of the seat,I,ll be getting rid of the auto meters and use stock dash and column shift