The 1947 - Present Chevrolet & GMC Truck Message Board Network - does someone make an original style starter for a 168 tooth flywheel?

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)

- The 1960 - 1966 Chevrolet & GMC Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=6)

- - does someone make an original style starter for a 168 tooth flywheel? (https://67-72chevytrucks.com/vboard/showthread.php?t=639604)

JWG	08-14-2014 08:50 PM

does someone make an original style starter for a 168 tooth flywheel?

I'm installing a Ramjet 350 into my '65 C10. The Ramjet has a one piece rear seal so it uses a special flywheel which is 168 tooth. Does someone make an original stye starter, but for a 168 tooth flywheel, or will I have to change my flywheel to a 153 tooth? :(

JWG	08-14-2014 09:00 PM

Re: does someone make an original style starter for a 168 tooth flywheel?

or better yet... any issues with using my block mounted mini starter that's already on my ramjet with the factory bell housing that normally would use a bell housing mounted starter?

JWG	08-14-2014 09:13 PM

Re: does someone make an original style starter for a 168 tooth flywheel?

Quote:

Originally Posted by JWG (Post 6802255)

or better yet... any issues with using my block mounted mini starter that's already on my ramjet with the factory bell housing that normally would use a bell housing mounted starter?

actually I just found some info online that answered my question

Quote:

The cast iron bellhousings with flange mounted starters can be used on all V8's 1962-on. These can be used with block mounted starters by grinding the lower portion of the housing to clear the block mounted starter casting.

source:
http://www.novak-adapt.com/knowledge...shift_info.htm

All times are GMT -4. The time now is 11:15 AM.