![]() |
help!help!
will a 59 half ton apache rear end work on my 63 half ton c10 ??any info will be much appreciated thanks
|
Re: help!help!
If your talking stepside then here's a link that discusses the interchangeability between the different series.
http://www.mar-k.com/bed_side_interchange_gm.aspx |
Re: help!help!
If you are talking about the rear end the answer is no.
Jimmy |
Re: help!help!
just changed the rear axle ass. in 63 c 10 went to a 66 I'd say ya can't go down only up. the frames are different. is that the deal guys?
|
Re: help!help!
Trap good information thx but I was referring to the rear end.Jimmy thanks
|
Re: help!help!
Why would you want to go from a truck 12 bolt to an older differential that is getting more difficult to get parts for and that most likely has a lower gear than your 12 bolt? The '59 Eaton HO32/33 will be setup for leaf springs. Your '63 should have trailing arms and coil springs.
|
All times are GMT -4. The time now is 05:33 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com