big block headers for 73-87 1/2 ton ?
 

im looking for big block long tube or Fenderwell headers for my 82 c10,
Im doing my engine swap this spring and im collecting parts now. any help will be greatly appreciated.

Re: big block headers for 73-87 1/2 ton ?
 

Is there a reason that you don't want to use an off the shelf header such as the Hedman 69110 or one of it's variations?

Re: big block headers for 73-87 1/2 ton ?
 

I was looking for bigger primary tubes like 1 7/8'' or 2'' but thanks for the part # on the hedman's

Re: big block headers for 73-87 1/2 ton ?
 

A set of Chevelle headers will work in a truck chassis and will be easier to find in the primary size you want. There is a thread here somewhere showing the Chevelle headers some guys are using.

Re: big block headers for 73-87 1/2 ton ?
 

I'm using chevelle headers on my '69, mainly due to the truck being so low, any full length truck headers would've been about an inch of the ground while driving. I'm using hedman Elites for a chevelle and they tuck up nice and tight - the don't hang down lower than the framerails. A-arm clearance is good, but depending on the motor mounts you're using, you may have to trim the bracket that bolts the engine if you're using clamshell style mounts. I'm using the '72 only clamshell mounts and had to notch the bracket on the driver's side a bit, but it turned out fine.

Re: big block headers for 73-87 1/2 ton ?
 

This is what im looking at
http://www.summitracing.com/parts/hok-2455hkr

Re: big block headers for 73-87 1/2 ton ?
 

Here's a look at the hedmans.

Re: big block headers for 73-87 1/2 ton ?
 

Is this the header part #68198 and that's a nice truck.

http://www.summitracing.com/parts/hed-68198/overview/

Re: big block headers for 73-87 1/2 ton ?
 

Yep, that's them. I would've liked to have 1 7/8", but the fit of these was really nice and they are very well built. I probably won't miss the 10hp or so I lost.