Manual to Power brakes question
 

Quick question...

When swapping from manual to power brakes, do I need anything other than the following:

1. Pedal Assembly
2. Brake booster
3. Master cylinder

I'm thinking of changing out my setup now for vacuum assisted brakes. Will I run into needing any additional parts than the ones above? The brake lines and things of that sort that are already in place should be fine and bolt up to the MC, right?

Thanks in advance for the help!

Re: Manual to Power brakes question
 

I suspect you'll need to fabricate or buy the lines that connect to the MC, because it will be moved farther forward by several inches.

So, the brake pedal setup is different? I guess the power version must have less mechanical leverage.

BTW, my 82 C10 has manual brakes and I am very pleased (almost shocked) at how well they work. Of course it's a relatively light, short wheelbase truck, and I've never hauled anything heavier than a few hundred pounds.

Re: Manual to Power brakes question
 

I did this swap a few years ago and only changed the booster, master cylinder and the lines going to the master cylinder from the proportioning vavle. I was able to re-use the original brake pedal with some modification.

Re: Manual to Power brakes question
 

The manual brake pedal takes a different size pin for the pushrod than the power brake pedal. I really don't have a huge issue with the manual brakes, but power brakes are a nice add-on. I don't know if maybe I should just remove my clutch pedal and keep it as is. I think where the clutch MC goes into the cab through the firewall, there will be a hole left over if I remove it, and I really don't want to have to weld it up. I'm at a crossroads!

Re: Manual to Power brakes question
 

I got your email and will respond. I like power brakes and have had c10 trucks with both. If you have only had manual brakes on one of these you really don't know what you are missing. Manual brakes ARE fine in most situations. I just like have power brakes. It seems to me you are at a good point to upgrade to them.

Re: Manual to Power brakes question
 

Ok, thanks. I am at a good point in my build, I just don't want extra expense or additional work I'm not too experienced with like welding closed a hole in the firewall left by the clutch MC.

Re: Manual to Power brakes question
 

The hole in the firewall doesn't have to be welded. Cut out a plate the shape of the mounting area of the clutch MC, drill two holes in it put a bead of silicone on the back and bolt it where the master cylinder bolted. I did something similar to this as my truck had a manual pedal assembly with the rod for the z bar going through the floor when I switch my truck to an auto trans. You can use nice button head allen bolts and it will look clean.

Re: Manual to Power brakes question
 

That's a great idea. I made a deal with natedogg on the setup. I'll still have the hydraulic pedals, so keep in touch with me. I'm sure we'll be able to make something work.

Re: Manual to Power brakes question
 

I removed the hydraulic clutch reservoir, MC and slave cylinder today. To take out the pedal assembly I assume I am going to have to drop or remove the steering column? I also pulled a wire from the main harness. Not sure where it went into. It's yellow. Good thing I have a diagram or I'd be in for some real fun...

Re: Manual to Power brakes question
 

Yep, you have to remove the column.