308 rear end
 

REAR END IS SOLD PENDING PAYMENT TO MRWELD

I have a rear end 308 ring and pinon and all hardware for sale. asking 125.00 plus shipping. I took it out of the rear end housing

Re: 308 rear end
 

Just the ring and pinion or is the carrier included?
what rear end is it for? 12 bolt? Do you have pictures

Re: 308 rear end
 

Everything except the housing. It would cost too much to ship the housing so I got read of the housing as junk. carrier included

Re: 308 rear end
 

Hey George,

quick question, will this just bolt in or will adjustments/ setup be needed? I.e. backlash adjustments , etc.

Thanks,

Re: 308 rear end
 

Steve, you will need to set up the preload on the side carrier bearings and the pinion bearings. All that is required on the pinion is a new crush sleeve, but the side bearings use shims. If you are not replacing the bearings, you should be able to reuse the shims that were there. I would not advise reusing the crush sleeve though. Oh, and a new pinion nut or some loctite on the existing one.

Re: 308 rear end
 

thanks 70stovebolt for answering Steve's question, now I don't have to.

Re: 308 rear end
 

Thanks for the quick answer! Is something that can be done by someone who has never done it before?

Re: 308 rear end
 

I want the gear and carrier, PM sent..

Re: 308 rear end
 

rear end is yours sending you a PM