![]() |
custom engine bay wiring ideas for LS swap
I have smoothed out most of my firewall, got rid of the heater box and all holes other than the necessary ones. I am putting a 5.3L in it and am wondering where have you guys ran the harness so it's very clean and not visible. I am going to be putting the fuse panel and ecm under the dash in behind the glove box. Anything helps so keep it going. I was going to do a bulkhead connector for the engine and body harness so it's sealed and easy to access.
|
Re: custom engine bay wiring ideas for LS swap
Check out the LS swap section for ideas and also may be a better place to ask this question.
Jimmy |
Re: custom engine bay wiring ideas for LS swap
Some aftermarket harnesses run under the intake....
|
All times are GMT -4. The time now is 02:27 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com