The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   The 1967 - 1972 Chevrolet & GMC Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=3)
-   -   Question about clutch Z-bar mounting stud (https://67-72chevytrucks.com/vboard/showthread.php?t=736738)

saxart 04-30-2017 10:25 AM

Question about clutch Z-bar mounting stud
 
Quick question...

Does anybody know of a cheap replacement for the rubber "O-ring" that is on the engine side z-bar mounting stud for the clutch bell-crank? (V-8 and SM465 manual transmission) Mine is disassembled right now, and once I cleaned it up everything looks to be in great shape, but the rubber piece that goes in the groove on the engine side ball-stud disintegrated when I first pulled it apart.

For those who know what I'm talking about, I'm calling it an O-ring, but it's more of a flat ring of rubber. You can see a pic of it in this thread:

http://67-72chevytrucks.com/vboard/s...d.php?t=709642

Any thoughts are appreciated. ;)

B. W. 04-30-2017 11:17 AM

Re: Question about clutch Z-bar mounting stud
 
I believe that the rubber washer comes with the ball. Most of the aftermarket balls don't have the rubber on them, they have the groove cut but no rubber washer. I did a quick search on Ebay (GM clutch ball) a new one came up with the rubber piece for $14.00 but it may not be the correct one for your application.

midniteblues 04-30-2017 05:14 PM

Re: Question about clutch Z-bar mounting stud
 
Its really just a grease seal. You could slice a sliver of heater hose or a faucet washer or something and use it.
It's nice to have something in between the block and bar for some cushioning too.


All times are GMT -4. The time now is 02:17 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com