| hewittca |
05-01-2017 08:51 AM |
Re: 67 c10 in the sky...
Quote:
Originally Posted by kgmunro
(Post 7930488)
So i have a 67 c10 with a conversion to disc up front. I had 3 inch drop spindles and coils with one ring cut off. Problem i had was with am 8 inch rally truck rim my control arm lip contacted the rally wheel. I put the stock spindles on yesterday and now it looks like a 4x4. What can i do to drop it two inches yp front? Can i just buy a two inch drop coil? Thats what i would like to do but i prefer not to use these spindles until i get larger wheels. Just not sure...will a two inch coil actually drop two inches?
|
If you already have one coil cut from the spring, that's about a 2" drop. You'd need a 4" spring to get an additional 2", which is a big drop on a spring up front. They are available, but you will have to cut out the bump stop brackets and put in new bumpstops. Alternatively, I know a lot of guys are cutting the lip off the lower A-arm where it hits on 15" wheels and have had no issues with this mod. I know it's commonly done for 2.5" drop spindles, but I'm not sure how much worse the interference issue is with 3" spindles. Either way, you are going to have to do some cutting to get those 15" wheels to fit. |
