Tilt Column, $329 shipped
 

This is a van tilt that I converted to fit our trucks.

Completely disassembled, bead blasted and painted. Bearings cleaned and lubed.

Back up lights switch moved to proper lower column location and proper truck grommets and lower retainer installed.

Upper grommet and tilt lever are new reproductions.

Turn signal switch was disassembled, cleaned and lubed, no cracks in turn signal cam. Purple wire has a butt connector.
Shifter pin hole is a little loose, shifter arm spring tension seems to hold pin ok, I would epoxy the pin after install and that would fix it.

Re: Tilt Column, $329 shipped
 

Another picture

Re: Tilt Column, $329 shipped
 

If its a van tilt....is it the right length? or has it had the length changed to suit the pick-ups?

Thanks
Coley

Re: Tilt Column, $329 shipped
 

The center shaft stick out on this van tilt is about 2.5 inches more than a truck column which requires you to collapse your intermediate shaft, lots of threads on here how to get that done, most of those threads suck and are full of misinformation.
You can collapse the one you have or I can provide one ready to install for another $50.

Re: Tilt Column, $329 shipped
 

Had this sitting on my deck for a week or so, it’s pleasing to look at...who needs a nice column?

Re: Tilt Column, $329 shipped
 

ttt

Re: Tilt Column, $329 shipped
 

Randy if i purchased this whats the chances you could paint it victory red. How much extra to paint it Thanks Bob

Re: Tilt Column, $329 shipped
 

I can’t paint it.

Re: Tilt Column, $329 shipped
 

Ttt

Re: Tilt Column, $329 shipped
 

Ttt

Re: Tilt Column, $329 shipped
 

So is this ready to bolt in to my 71 burb or would it need to be modified?

Re: Tilt Column, $329 shipped
 

Read post 4, needs intermediate shaft collapsed, column is ready to bolt in