[69 longhorn]

You can bolt a saginaw 4spd ,or M 20/21 muncie to the bell. Pilot hole size will be different. On the saginaw trans,you can use the front bearing retainer/throw out collar from a sag 3 spd. On the Muncie,you can have a ring made to press over the OD of the bearing retainer,or use a 67 or earlier bell for proper center hole size. You can also use the M22,& Borg T 10,but may have to change the clutch(spline count). You will need the drive shaft from a 3 spd stick,or a 350 T auto truck,& whatever you choose to use for a shifter. the bottom trans to bell bolts will go through from the inside, & have to have a nut..........69 longhorn