Quote:
|
Originally Posted by 1969 modified
Thanks newbe351, that's the same measurement I've got (about 1/16th of an inch). There are two flat supports on both sides of the wheel opening that I had to cut loose on both sides to repair a couple of holes that are created by the moisture that gets trapped behind these support. I replaced the supports to the original location, but I figured that I had created a warp. I have a feeling that there is supposed to be a slight dip on both sides. I have a decision to make......leave it like it is or make it flat while I'm doing the body work. Thanks for checking for me.
Modified69, 97 work truck, 94 lifted, 65 in process.
|
I was reading some of the online tech articals for Project Old School and they mention that this is a major problem area of these year trucks. I haven't even looked at mine since 1/16 is of little concern when there is a hole in the floor that a small child could crawl in and out of
PanelRodder