|
Re: where to get caps and rings for rally wheels?
Quote:
Originally Posted by jdurant
About trim rings:
I think I am going to do 8" fronts and 10" rears. So I was wondering if there is a trim ring that will look the same but go deeper into the wheel for the rears. So have two different trim rings. Fronts(correct me if I am wrong) are 3" wide. So in the back maybe 4" wide. Has anyone done this succesfully?
|
I used to set steel wheels up the same way but the problem I found was the trim rings didn't look the same. I wanted the exact same ring but w/different depths & struggled to find them consistent when searching the 'used' sources. That's when I noticed the 88-98 truck trim rings just covered the initial lip of the wheel which IMO 'displayed' more of the wheel itself vs. covering it up.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|