where to get caps and rings for rally wheels?

[SCOTI]

Originally Posted by jdurant

About trim rings:
I think I am going to do 8" fronts and 10" rears. So I was wondering if there is a trim ring that will look the same but go deeper into the wheel for the rears. So have two different trim rings. Fronts(correct me if I am wrong) are 3" wide. So in the back maybe 4" wide. Has anyone done this succesfully?

I used to set steel wheels up the same way but the problem I found was the trim rings didn't look the same. I wanted the exact same ring but w/different depths & struggled to find them consistent when searching the 'used' sources. That's when I noticed the 88-98 truck trim rings just covered the initial lip of the wheel which IMO 'displayed' more of the wheel itself vs. covering it up.

[kevinr1970]

Originally Posted by SCOTI

I purchased my caps from PICKMUP here on the board. Good price & quality.

I wasn't aware he carried something like that. All the better to support those that support the board!

Originally Posted by SCOTI

That's when I noticed the 88-98 truck trim rings just covered the initial lip of the wheel which IMO 'displayed' more of the wheel itself vs. covering it up.

But aren't the '88+ wheels 16"? Do the rings still fit or are you referring to a 15" ring from like an S10?
My 15x8's are either powder-coated or painted red. I was running what I believe are the stock 15x8 trim rings but they did cover too much of the rim. The truck my girlfriend had when we met had painted steelies with baby moons(?); her dad built it for her. The trim rings that were on there were mabe an inch wide and left rim exposed on the inside and the outside of the ring. It looked like just a chrome stripe around the outside of the rim.
Those are the rings I want to get but they have been a back-burner priority.