The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Hallz · 06-20-2008, 06:04 PM

Thanks guys,

Yeah I have the flexplate, I do need to buy a new stock converter though. I am only swapping out to a auto so it will be easier for the woman to drive. Even then if it was not for the whine in the transfer case or trans I would just have her get use to it. But from the reading the Rockwell is a b!t<h to get parts for so I figured it would be easier to swap it vs repair it.

Any tips on isolating the whine to the transfercase or tranny?

Also, I may hold off a bit till I put a small lift on it to clear the 35's I got with the truck.

06-20-2008, 06:04 PM	#4
Hallz Registered User Join Date: Jun 2008 Location: Sacramento Posts: 20	Re: 4spd/Rockwell to TH350/205 swap Thanks guys, Yeah I have the flexplate, I do need to buy a new stock converter though. I am only swapping out to a auto so it will be easier for the woman to drive. Even then if it was not for the whine in the transfer case or trans I would just have her get use to it. But from the reading the Rockwell is a b!t<h to get parts for so I figured it would be easier to swap it vs repair it. Any tips on isolating the whine to the transfercase or tranny? Also, I may hold off a bit till I put a small lift on it to clear the 35's I got with the truck. Last edited by Hallz; 06-20-2008 at 06:05 PM.