The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Temp Gauge ?

lts70 · 08-05-2008, 01:53 PM

I have left the oil pressure part of the gauge installed while removing the rest of the cluster before so it can be done. Just unscrew the screws that hold the access plate to the rest of the cluster. I did this so I could still run the truck while I installed an alarm system with out getting oil all over the place when the motor was running. It is nice to have the option of moving the truck if you need to while working on it, then you don’t have to buy a cap off fitting.

08-05-2008, 01:53 PM	#10
lts70 1970 Daily Driver Join Date: Jun 2007 Location: Glenns Ferry IDAHO Posts: 1,038	Re: Temp Gauge ? - Simple I have left the oil pressure part of the gauge installed while removing the rest of the cluster before so it can be done. Just unscrew the screws that hold the access plate to the rest of the cluster. I did this so I could still run the truck while I installed an alarm system with out getting oil all over the place when the motor was running. It is nice to have the option of moving the truck if you need to while working on it, then you don’t have to buy a cap off fitting. __________________ It's not truly yours if you didn't build it yourself or if you don't do your own maintenance. Last edited by lts70; 08-05-2008 at 01:54 PM.