The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

JimKshortstep4x4 · 02-03-2009, 08:56 PM

I use large washers for shims.

I have tried to reduce the radiator support bushings but what I have found is that you almost have to go with no supports at the radiator in order to get the results equivalent to 1/4" shims under the body.

I have not seen any problems from shimming under the body.

Jim

02-03-2009, 08:56 PM	#4
JimKshortstep4x4 Senior Member Join Date: Jul 2001 Location: Muskegon,MI,USA Posts: 6,026	Re: cab shims I use large washers for shims. I have tried to reduce the radiator support bushings but what I have found is that you almost have to go with no supports at the radiator in order to get the results equivalent to 1/4" shims under the body. I have not seen any problems from shimming under the body. Jim __________________ 1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC