The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

72bigred · 01-24-2010, 01:29 AM

Yes I remember that post. It stated to pull the torsion out and rotate it "this far" I assume you would rotate it so that it would initially have less spring rate so you would then have to tighten your bolt up further in order to achive some type of spring rate. Since you rotated it whatever distance in the tightest setting you would be lower than factory height. Yet I also read that someone tried this and it did not work for them..but did they rotate far enough.. I would make sence that it would work.. I although have not tried..

Reid

01-24-2010, 01:29 AM	#9
72bigred Registered User Join Date: Jan 2008 Location: Spokane WA Posts: 254	Re: torsion bar "lowered" help Yes I remember that post. It stated to pull the torsion out and rotate it "this far" I assume you would rotate it so that it would initially have less spring rate so you would then have to tighten your bolt up further in order to achive some type of spring rate. Since you rotated it whatever distance in the tightest setting you would be lower than factory height. Yet I also read that someone tried this and it did not work for them..but did they rotate far enough.. I would make sence that it would work.. I although have not tried.. Reid Last edited by 72bigred; 01-24-2010 at 01:30 AM.