The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Jonboy · 09-01-2010, 09:56 AM

If you are planning on running hte later front sheetmetal, the rail ends are just cut off at an angle. If you are going to run the earlier stuff, then you are ready to go.

09-01-2010, 09:56 AM	#4
Jonboy Slots go on anything! Join Date: May 2003 Location: Richardson, TX Posts: 5,957	Re: Frame Swap If you are planning on running hte later front sheetmetal, the rail ends are just cut off at an angle. If you are going to run the earlier stuff, then you are ready to go. __________________ 1974 Jimmy- 5.3/4L80e/NP241