[C10longwb]

Your best bet if your going to do sheet metal is to
get a 140 110v mig welder it will give you beter peniteation and less prosity inthe weld witch= less prep time If you sit there and try to
fix all the bubbles from the flux welders you'll get pissed off and say this is a waste of time. If your looking for good quality at cheep get a Hobart 140 I have the step up the 187 but I like to play around with thicker stuff like 1/4 and 3/8 you should have a fairly close local welding shop get your tank filled and supplies there get a bottle off someone local because the weld shops are expensive.. My 150 bottle was 200 and they wanted 175 for a 75... But for wire and tips and the gas it'such cheeper to go
though a weld shop good luck
Posted via Mobile Device