View Single Post
Old 03-09-2012, 05:04 PM   #7
jaros44sr
Senior Member
 
jaros44sr's Avatar
 
Join Date: May 2006
Location: Philadelphia, Pa. 19454
Posts: 9,843
Re: tilt column rebuild Qs

Quote:
Originally Posted by michael bustamante View Post
you know thats a good idea. I didnt even think of my 70 chevy service manual.
ill check out those websites now. the bearings still feel good so hopefully I wont have to replace them. I mainly have to tear apart the upper portion where the tilt is to run the turn signal switch wiring. but Im check those bearings for sure now
classic heartbeats.....ill drop wes an e mail
If all you have to do is replace the switch, there is a way to do that without tearing much apart other then the cover
__________________
Semper Fi...Uncle Sam, you da man

All parts offered to help are free, unless otherwise noted

Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training
SAFETY FIRST

AS usual, off topic

They say your mind goes second, can't remember the first


Jim
jaros44sr is offline   Reply With Quote