Quote:
Originally Posted by 85burb
The motor is gona need some work if you plan on spinning it that fast. LS1tech has tons of info. The least i can think of is the best arp rod bolts with rod resizing and main studs. I am sure ls1tech.com has all the nessecary parts lists. Just be care full if you post over there with out searching first. Some of them on that site are jerks.
|
Thanks, I signed up there earlier and made an introduction post but haven't had and replies yet. I kinda saw what you're sayin about the place, they don't seem overly friendly over there. I was planning on running afternarket forged rods, unless the stock ones could be beefed up? I read that LS6 Z06 engines had lightweight hollow valves that would be good for high rpm's. I think GM discontinued them though.
Posted via Mobile Device