Thread: ac condenser??
View Single Post
Old 06-24-2012, 05:12 PM   #7
hatzie
Moderator
 
hatzie's Avatar
 
Join Date: Oct 2008
Location: Wentworth, NH
Posts: 5,020
Re: ac condenser??

Quote:
Originally Posted by 86c20 View Post
sorry guys i am not up and the ac names. i need the one on the fire wall. i thought that was the condenser. must be the evaporator??? and was told a new dryer too can i ask why? thanks and sorry for my mistake. later, mike
Quote:
Originally Posted by 86c20 View Post
sorry guys i am not up and the ac names. i need the one on the fire wall. i thought that was the condenser. must be the evaporator??? and was told a new dryer too can i ask why? thanks and sorry for my mistake. later, mike
The Evaporator is fairly easy to replace. Install a Variable Orifice Valve at the same time.

You need a new drier any time you crack open an AC system or have a leak because moist air quickly saturates the desiccant pak. You should wait to remove the seals and install the new drier just before you vac the system down.

Once the system is sealed crack the high side port and blow a dry inert gas like Nitrogen, CO2, or Argon through the sealed system from the low side port. Blow it through for a couple minutes to sweep out most of the moist ambient air. This should keep the oil and drier from absorbing too much moisture. It'll make your vacuum pump happier too.

Updating to R134.
You will want to make sure that there is a High Pressure cutout switch installed and that the High and Low Pressure Cutouts are set up for R134 pressures.
You can get away with cutting off the collars and replacing the flexible portion of the lines with new barrier hose and new crimp collars.
Every O ring in the system will need to be updated to R134 spec.
You'll also want to flush the R12 oil out of the lines and condenser (unless you upgrade the condenser).
Installing a high efficiency parallel flow condenser will keep the vent temps down when idling.
Drain and refill the compressor with a full charge of Ester oil. Ester won't have a conniption over the dregs of R12 mineral oil left in the system and it's less hygroscopic than PAG oil. Don't burn the old mineral oil. It probably still has some R12 trapped. You do not want to breathe Phosgene gas.
__________________
1959 M35A2 LDT465-1D SOLD
1967 Dodge W200 B383, NP420/NP201 SOLD
1969 Dodge Polara 500 B383, A833 SOLD
1972 Ford F250 FE390, NP435/NP205 SOLD
1976 Chevy K20, 6.5L, NV4500/NP208 SOLD
1986 M1008 CUCV SOLD
2000 GMC C2500, TD6.5L, NV4500
2005 Chevy Silverado LS 2500HD 6.0L 4L80E/NP263
2009 Impala SS LS4 V8


RTFM... GM Parts Books, GM Schematics, GM service manuals, and GM training materials...Please include at least the year and model in your threads. It'll be easier to answer your questions.
And please let us know if and how your repairs were successful.
hatzie is offline   Reply With Quote