The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Truck runs fine for about an hour or 90 mins then dies

Juiceball · 12-31-2013, 12:14 AM

Yep. New module and used the grease. The condenser lead was all twisted up and routed between the base plate of the distributor and the top of the engine so it was sitting right on top of the motor. I rerouted it so it went directly from the base plate to the cap. Was going to replace that (and condenser) next to make sure there isn't a broken or frayed wire that's getting to hot and choking out the signal from to many ohms due to heat.

12-31-2013, 12:14 AM	#5
Juiceball Registered User Join Date: Dec 2013 Location: East Helena Posts: 6	Re: Truck runs fine for about an hour or 90 mins then dies Yep. New module and used the grease. The condenser lead was all twisted up and routed between the base plate of the distributor and the top of the engine so it was sitting right on top of the motor. I rerouted it so it went directly from the base plate to the cap. Was going to replace that (and condenser) next to make sure there isn't a broken or frayed wire that's getting to hot and choking out the signal from to many ohms due to heat.