|
Re: 89 CC C30 e-brake cable
Quote:
Originally Posted by mrolds88
Make sure parking brake pedal is all the way up. Then pull the cable at #5 sideways. This pulls the cable out of the sheath. Put a pair of vise grips on the cable right at the end of the sheath. This will give you room to work. Being careful, use a small screwdriver to lift the little tab that locks the cable end in. Then slide the cable out. I had to do this on one of my trucks when the adjustment nut rusted to the threaded rod.
|
Ok.... I tried w/an awl but felt like the awl was going to break before the clip came apart from the cable ends. The awls leverage ability is obviously not much (because of it's length/diameter), but something longer/thicker didn't seem to fit.
I guess I'll spray everything down & try again now that I know the clips are available.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|