Quote:
Originally Posted by luvbowties
My truck, 1966, is obviously older than yours. But, I too had a problem making from scratch the pass-side tail pipe--also due to interference from flex brake hose & mounting tab. We just installed a slightly longer rubber hose & moved mounting tab over a bit to re-locate the hose/tab & were able to fit the pipe just like driv-side. I, too, have a fuel cell under the back of my '66. NOTE: We (the muff-shop) made up all my pipes from scratch--no pre-packaged kit at all; thus, he had no excuse-- AFTER I went & brought a longer flex hose to him!!!
Hope this will help u solve your dilemma. 
Sam |
Thanks Sam,
Didn't you have to also redo the hard lines going to the wheel cylinders if you moved the tab? On my truck, the lines are an exact fit, If I moved the tab either direction, the hard lines wouldn't fit any longer. Thanks!