Quote:
Originally Posted by nsb29
I have a 6l80e from 09 GTO I wont to run a one piece driveshaft I have heard I could use a 400 bolt on yoke and have it machined to replace the 3 bolt flange looking for some input or a better idea thanks doug
|
Running a Machined TH400 bolt-on yolk & a drive shaft with a incorporated HD slip yoke is the ticket, The Machining is simple, And you have the G8/Camaro Yolk to take to the machinist.
Yolk,
http://www.ebay.com/itm/Transmission...-/130322434555, This is Cheap! Is has a Spicer part# but not sure if it is Spicer or not.
DriveShaft,
http://www.dennysdriveshaft.com/p136...lip.html#photo.
I also recommend a 1350 Yolk for the rearend as well to make the U-joints the same.