The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - What would you do with a bent crossmember in the rear

Ruscal · 06-29-2016, 10:24 PM

I found a couple of pics, but no good ones of the completed xmember. It is made from 1x3x1/8". I expanded the ends to match the frame channel ID. Threaded inserts were welded into the ends to match up to the existing frame bolt holes. I fabbed the custom hitch to tie into it adding a little strength.

06-29-2016, 10:24 PM	#14
Ruscal Registered User Join Date: Jun 2013 Location: Carlsbad, California Posts: 165	Re: What would you do with a bent crossmember in the rear I found a couple of pics, but no good ones of the completed xmember. It is made from 1x3x1/8". I expanded the ends to match the frame channel ID. Threaded inserts were welded into the ends to match up to the existing frame bolt holes. I fabbed the custom hitch to tie into it adding a little strength. Attached Images __________________ RC