View Single Post
Old 04-27-2017, 07:17 PM   #7
jeffahart
Senior Member
 
jeffahart's Avatar
 
Join Date: May 2012
Location: Scottsdale, AZ
Posts: 1,910
Re: Looking for 71-72 transfer case shift lever

OK. I'm guessing you don't know the exact bends you need, just that yours does have the correct bends. If you look at my stick you will see it bends toward the driver. What you don't see, under the boot, is the stick has two 45 bends. So it comes off the transfer about 2" the takes a 45 bend to the driver for 4" the bends 45 back up through the boot. If you sit in the truck it looks like you wont be able to shift the trans if you put it into 4Lo. But the stick kind of drops down when shoved up into 4Lo. So the bends can be deceiving.

Anyhow, I think you need to figure what the bending configuration should be before you grab one. Or verify the application from the buyer. If Special K chimes back in he can probably shed more light on what actually came in that year, he has had several 4x4s of this generation. Point is, you could get a transfer stick that does not play well with your transmission stick... that would be my concern. You can always bend the stick you have until it works, then paint it black! Or like he said below, give quad 4x4 a ring.

Pics, we like pics.... because we're nosey!
__________________
White K20
jeffahart is offline   Reply With Quote