|
Re: Seat Covers
Quote:
Originally Posted by TKCR
The only problem I have had with Classic Industries seat covers, are the covers for the 73-80 seats, like yours. Did you have any issues with the seat bottom being extremely hard to install? I have used 3 covers and all of them have been almost too short. The last one actually ripped, trying to get it to go on. All the 81-87 covers have been fine.
After getting a refund for the cover that ripped, I ordered another 73-80 cover from USA1 Industries. The fit was perfect. I had measured the Classic Industries cover before sending it back and then I measured this new one. The USA1 cover was 4" longer than the cover that ripped.
Here's a pic of it. It is installed on 77 tilt seat, Camel Tan
|
The seat bottom was a little tight but after a little wrestling it went on alright. It stayed tight and there aren't any wrinkles and hasn't seemed to cause any issues.
__________________
'51 South Bend Model "9A"
'56 Chevy 3600 NAPCO
'74 Chevy Cheyenne Super K20-restored on 37's
'72 GMC Sierra Custom K2500- in progress
'08 GMC Envoy Denali
'12 GMC Sierra 2500HD Denali
'17 GMC Yukon XL
VCCA member #58596
http://www.nohrco.com
|