The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**Accelo** · 08-29-2021, 01:43 AM

I always use never-seize on new screws.
If you can't get them out just drill the head of the screw off. Then you can get the door panel off. Then I use vice-grips on the back side and unscrew them to the inside of the door. You can heat them if necessary with the panel off. I was always amazed how quickly these will seize if left unprotected with some type of lube.

08-29-2021, 01:43 AM	#10
Accelo Senior Member Join Date: Mar 2015 Location: washington Posts: 2,358	Re: Door panel screws question I always use never-seize on new screws. If you can't get them out just drill the head of the screw off. Then you can get the door panel off. Then I use vice-grips on the back side and unscrew them to the inside of the door. You can heat them if necessary with the panel off. I was always amazed how quickly these will seize if left unprotected with some type of lube.